- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-22-2021 03:19 PM
Hi, guys
I delete vlan 1 somewhere when config the ap7522 through WebUI. when commit the config, there is error message:
---
Detail :Not Available
Message :Overloaded interface vlan1 in NAT config is not present
ErrorPath :/wing-config/device[mac=74-67-F7-A1-AE-58]
Severity :error
Type :Application Error
**********************************
---
how to fix it?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-23-2021 04:22 PM
- I don’t remember location when delete it.
- I don’t need vlan 1, and I have create another vlan as mgt vlan.
- Thanks anyway, I have reset the ap to factorydefault, and config it again. the error message just gone.
yes, I config the ap through serial console right now, cli is my favorite.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-23-2021 04:22 PM
- I don’t remember location when delete it.
- I don’t need vlan 1, and I have create another vlan as mgt vlan.
- Thanks anyway, I have reset the ap to factorydefault, and config it again. the error message just gone.
yes, I config the ap through serial console right now, cli is my favorite.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-23-2021 01:07 PM
zlinuxboy: If you are not already doing so, you likely need to console connect to the AP to fix this.
Once in, you can re-create vlan1 - Or, you can do as stated above and just reset the AP and start over.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-23-2021 12:28 PM
1 - Where did you delete it from (profile or override)?
2 - Do you need vlan 1?
3 - Did you configure another native vlan?
You can very simply reset the AP and start anew. This will assure that all settings are reinstated.
Thank you,
