Network Architecture & Design - Page 59 - Extreme Networks

Network Architecture & Design

Questions and discussions about network architecture and design in general

Forum Posts

Sorted by:

Start a conversation

Need some assistance translating a config file

I have a basic Cisco config I need to translate to EXOS. I'm looking for an Extreme guru to assist. The following is a config file. the IP addresses are arbitrary subnets in my local GNS3 topology: R1#show runnR1#show running-config Building config...

aggregate two infrastructures (basic vlan question)

We have two seperate infrastructures: - 'video system' (10.10.10.0/24 subnet, four enerasys 0820G4-48, all in one Building); - 'pc farm' (192.168.1.0/24 subnet, four extreme x350, locate on four different Buildings and seperate from video). Both "...

wireless - MU duration report

Hi, my customer is interested to get a report/output for the duration of the MUs that were connected to his guest WLAN - let's say once a day. Is there a way to do it with Netsight/OneView or only the controller. I've found the MIB value "muDuratio...

a2h124-48 Firmware update failed CRC check all the time

Hi, i have an older a2h124-48 Switch with Firmware 02.01.01.x . I tried to update these to 03.03.06.01 - allways with the result: TFTP code transfer starting Verifying CRC of file in Flash File System Error: File failed CRC check! Same results wit...

looking for 10BaseT (Copper) on an enterasys switch

want to purchase a couple of Enterasys switches for a SAN environment and need 10baseT (RJ45), cant see anything in the transceivers document, any ideas

Top Kudoed Authors

User

Count

4

3

3

2

GTM-P2G8KFN