ExtremeSwitching (EOS) - Page 54 - Extreme Networks

ExtremeSwitching (EOS)

Questions and discussions about EOS

Forum Posts

Sorted by:

Start a conversation

Meaning of ARP operation code 3072

On an S-Series chassis we receive the following log messages: RtrArpProc[1]Received ARP packet with Operation code: 3072 All I can find is the RFC stating that 3072 is in the unassigned range.... Does anyone have an idea what that message could me...

SSA180 Bonding - wrong PSU fan speed output with show system hardware

Hello everyone! We have two SSA180 Chassis with bonding configured. If we now try to get the hardware status with "show system hardware" command at CLI, we can not see the fan speed of both power supplies in chassis 2. I have changed the power suppl...

OnePolicy "deny all" blocks STP on EXOS, but not on EOS

Hi, when replacing EOS based access switches (e.g. S-Series) with EXOS based switches with OnePolicy support (e.g. X460-G2 or X440-G2), there is a difference in behavior if a deny all policy is used. On EOS, STP BPDUs are not blocked, but on EXOS th...

EXOS 16.2.2.4 / BD8810 : Unexpected slot reset ( MSM-A: pibConduitMasterRcvOneSlot(): failed, rc=-6, errno=134, slot=3)

Hello, Please have some of you ever experienced this problem on Black Diamond 8810 : Unexpected slot reset while the switch was behaving normally before the failure. This happens from time to time and creates outage for a couple of minutes (restart...

Port channel between x440g2 48 p and cisco cat 6500

i have configured port channel on my cisco and extreme switch but when i connect the interfaces the port channel doesnt come up not sure what i am doing wrong here. please see configuration CISCO CONFIG --------------------------------------------...

Top Kudoed Authors

User

Count

4

2

2

2

2

GTM-P2G8KFN