Can we put multiple source address in the Access list polciy
can we make access policy with multiple source address since i am trying to do this but it is giving error in policy check
Forum Posts
Resolved! EXOS on GNS3 not booting past BusyBox
Trying to boot EXOS v32.6.3.126 on GNS3 v2.2.50 running as a VM on Hyper-V and cannot get past BusyBox. I don't see anything on the tutorial site about this. The only warning I see during boot is about the CPU:Warning. Could not determine the CPU Fam...
Resolved! Firmware double check on device
Hi, anybody here who can tell me the CLI command and the place where a new Firmware is stored?Something like (dir Flash: from Cisco) i am not able to verify that the new firmware is stored on the device (x440-g2)aprreciate your helpKR Uwe
Resolved! Dynamic Port Addition to Vlans for DHCP Snooping
We have a very fluid environment when it comes to port to vlan assignment. I see that using the command " enable ip-security dhcp-snooping vlan STUDENT_ITTSTAFF_849 ports all violation-action drop-packet block-port duration 15" enables dhcp-snoopin...
Resolved! EXOS 32.7.1.9-patch1-49 MIB Table IP-MIB.ipNetToPhysicalEntry 1.3.6.1.2.1.4.35 wrong entry type
Hi,we've noticed something in the new EXOS Image 32.7.1.9 Image regarding the ARP Table and the SNMP ipNetToPhysicalTable. In Console the entries are displayed correctly as dynamic. In The SNMP Table it displayed as static. I think something is wrong...
