ExtremeSwitching (EXOS/Switch Engine) - Page 120 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Resolved! ACLs Extended Deny subnet to access other subnet and allow others

Hi teamscan you write command on extreme to do same bellow commandip access-list extended 10010 deny ip 192.168.6.0 0.0.0.255 192.168.2.0 0.0.0.25511 deny ip 192.168.6.0 0.0.0.255 192.168.5.0 0.0.0.25512 permit ip 0.0.0.0 255.255.255.255 0.0.0.0 255....

exclude ip address from dhcp allocation range

Is there a way to exclude a range/single ip address from "configure vlan dhcp-address-range xxxx - xxxx" for example: configure vlan vlan_name dhcp-address-range 10.1.1.20 - 10.1.1.254 Can I exclude 10.1.1.60 from being allocated?

MSDP peer filter

Hello everybody.I’m struggling with a conf about msdp filter.I want apply outbound filter toward a msdp peer: configure msdp peer 192.168.1.2 sa-filter out msdp_policy_outmsdp_policy_out.polentry permit { if match any { nlri 239...

Resolved! Add new vlan in functionnal ERPS ring : Precaution

Hello,I want to modify protected vlan by adding a new one in switchs configured with an ERPS ring and I want to know the risk with this modification and what precaution to have doing this configuration.the switchs used in this ring is BD8810 and X690...

Resolved! Incorrect defaults in XOS 30.6.1.11?

I have just been setting up two new X590s with this version and found that two commands were enabled without me doing anything, yet the docs show that the default behaviour is disabledI suspect the docs are right and the config change is an error bec...

Top Kudoed Authors

User

Count

28

23

17

16

16

GTM-P2G8KFN