ExtremeSwitching (EXOS/Switch Engine) - Page 146 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

X460-48p Visio Stencil Error

I know it’s a long shot that this will be corrected, but the stencil for the X460-48p is incorrect. It shows the fiber ports are shared, even though they are correctly labeled as ports 49-52. The stencil for the X460-48t is correct. Also, it’s nice...

Resolved! How to ENABLE untagged vlan warning before changing automatically?

When adding a port to a VLAN sometimes the engineer forgets to add the tagged command at the end and it automatically changes the untagged VLAN. How can I enable a warning so that it asks if they are sure they want to do that and they have to press (...

Resolved! EXOS-27194,EXOS-27034 VPLS FDB is leaked on network VLAN when a flap occurs on MPLS cloud.

Dear employees!On my network on all of the Summit x670(first generation) in rare conditions I`am observing bug like this “EXOS-27194,EXOS-27034 VPLS FDB is leaked on network VLAN when a flap occurs on MPLS cloud.”This bug was fixed in xos-22 and xos...

Resolved! Updates for the x440-g2-48p-10ge4

I can't figure out where to download the firmware updates for the x440-g2-48p-10ge4 switch.Tell me please.

Resolved! XMC - Enable/disable ports at certain times

Hi I’m very new to XMC and I’ve seen on this board that it is possible to disable/enable ports at certain times. I’m interested in doing this for our DR but I don’t know how to. I’ve looked on XMC and can’t see anything obvious, I’m assuming you e...

Top Kudoed Authors

User

Count

32

29

20

20

17

GTM-P2G8KFN