ExtremeSwitching (EXOS/Switch Engine) - Page 165 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Rx Frag on a particular port printer connected

Hi All, I am facing an issue regarding incremental packet drop on a particular port with Rx Frag value is also increasing, I have checked/alter cables but nothing rectified following is the packet statistics of that port Port Packet StatisticsP...

How to disable a port in sharing

Hi All How can I remove a particular port once it is configured as sharing? Suppose the following is the command saved in switch. “enable sharing 1:24 grouping 1:24,3:24,6:24 algorithm address-based L2 lacp” Now I need to rem...

Resolved! MACsec performance on 5520 series / LRM/MACsec

Hi there,we are planning to use encryption of some of our new uplinks with 10GBe and wonder how stable and fast the links will be with MACsec enabled.Is there any analysis on how the performance on 5520 (5520-VIM-4YE) or LRM/MACsec will be? Further w...

Multiple vlan sharing the same bandwidth on an ACL

Hello, I would like to know how to make several vlan share the same bandwidth (meter) on the ACL. Are the following commands sufficient? ACL_VLAN1 : # RuleNo# 6entry rateLimitOut { if match all { source-address X.X.X.X/30 ;} then { meter mt...

xmit hash policy used in VDX 6740

I have a server connected to VDX-6740 HW in a 802.3ad LAG setup with 2 Ethernet links (Not sure about the exact setup. I am a user of your products, not the admin).I would like to have some control over the load balancing. For outgoing messages, it i...

Top Kudoed Authors

User

Count

33

29

21

20

17

GTM-P2G8KFN