ExtremeSwitching (EXOS/Switch Engine) - Page 166 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Resolved! When putty is full screen and you backspace a long command, cursor jumps up a line

This is a question that I have in regards to a 4 year old post. Where are we with this? This was 4 years ago and still I see this issue.Using Putty to SSH to EXOS 5520 on 31.1.1.3.If you type something like sh port 1:1-48, you have to maximize your ...

Mirroring on X590 - V400. Troubles with 802.1BR (0x893F) encapsulation

Recently we replaced our Enterasys S4 with a couple of X590 and associated V400 edge switchesWe are now facing problems regarding mirroring the traffic of our VLANs and checking the results on our network analyzer where we also NEED to run tcpdumpHer...

Resolved! X435 "mode" button

Hello! What for “mode” button on front panel of X435?(there is no information in HW Install Guide). Also, am I understand right that 2,5Gbps speed for now unavailable for X435?(When it will be available and what optics have to used?) Thank you!

Resolved! ECCN and HTS code

Hello, Appreciate if someone can provide me the ECCN and HTS codes for the Extreme Summit switch X430-24t. Thanks heaps. Ralph

Resolved! GARP in EXOS

Good afternoon, the GARP protocol is supported by EXOS versions? I have two Avaya SBCs in redundancy, and when making the switch it sends the GARP message but the FDB entry is stuck in the source port and it does not go to the destination port, can y...

Top Kudoed Authors

User

Count

32

29

20

20

17

GTM-P2G8KFN