ExtremeSwitching (EXOS/Switch Engine) - Page 223 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Resolved! Firmware upgrade question regarding regarding x465 switch?

Hello, I download the firmware from Extreme Network and I noticed they are onie-30.3.1.6.xos and onie-30.3.1.6-diagnostics.xmod. Do I need to install both of them? I know when I upgrade firmware for ERS switches. I install both diagnostic file and so...

Resolved! Copy firmware from secondary to primary

What command do we use to copy the firmware from secondary to primary?

Resolved! vlan routing for X465 extreme EXOS?

Hello all, I just received some new X465 switches, I just realized it is so different from the ERS switches. User interface is very simple and therefore almost useless for any advanced configuration. CLI is very different as well. I am mainly famili...

Extreme Summit x870-32c - 100Gb partition to 25Gb - port status always Active

HelloI don't see any correspondence btw extreme ports and link interfaces on my server.I have this design with 1 input port 100Gb , I have partition it : configure ports 1 partition 4x25Gconfigure port 1 auto off speed 25000 duplex fullconfigure port...

palo alto crashes network

I am using a PA220 and x440 switches together on a simple network. for some reason out of the blue the firewall crashes when connected to the switch. I have tested the PA where I pulled it out of the network and connected it to a Cisco 2960 and all i...

Top Kudoed Authors

User

Count

28

26

20

20

17

GTM-P2G8KFN