ExtremeSwitching (EXOS/Switch Engine) - Page 239 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

point to point inter vlan communication between extreme summit 48si and extreme x770

I have created a point to point inter vlan communication between extreme summit 48si and extreme x770, but unable to ping, because of static mac and also the summit switch is taking default configss on the port, pelasehelp with tshoot and commands to...

fdb lookup on vlan failed after 5 attempts

Error Message on the switch I am receiving several messages like this in my logs on Summit 460G2 running 16.2.4.5-patch1-5. The GTAC whitepaper suggest I should clear the snooping table for the entry however does not indicate how to accomplish this....

no netlogin sessions with legacy netlogin and Extreme Control

Hello, I've a problem with a X440 (G1) using legacy netlogin against Extreme Control. X440: 16.2.4.5 patch 1-6 XMC: 8.3 MAC-Authentication It's my first time to integrate a G1 into Extreme Control. No Problem with G2's and EOS. I can see Endsyste...

UPMPROFILE:

UPM profile is launch if one or port event (PortlinkstateUp) is caused. UPM profile set standard var (related just to UPM profile, so Param_0,Param_1 extc,exct... Question is: Is possible read the port(s) status and fix these as variable and then use...

EXOS "default next-hop" alternative for PBR

Hello, I can't seem to find out how to do a default next-hop instead of a next-hop when performing PBR. The default next-hop functions differently than next-hop alone. Here is the difference. Can someone help? https://www.cisco.com/c/en/us/sup...

Top Kudoed Authors

User

Count

28

26

19

19

17

GTM-P2G8KFN