ExtremeSwitching (EXOS/Switch Engine) - Page 288 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Resolved! Block SNMP traffic to devices

Hello all, I'm a bit of a exos newb and need assistance. Is there a way to create an ACL to specifically block SNMP traffic to a device connected to a port? I was thinking of using the GUI route and set up a dynamic ACL. Would this be a good idea or...

Stacking Ports Flapping X460-G2

We have 9 X460-G2 stacks running version 22.5.1.7 and we have noticed that the stacking ports are flapping on a regular basis. The link goes down on Stacking ports 1:2 and 2:1 then comes back up. Has anyone else experienced this problem? What was th...

Resolved! EXOS 30.1.1.4

after upgrading EXOS firmware to 30.1.1.4, the ability to scan the cable disappeared * CoreSwichCanon.4 # run script cablediag.py -p 20 cablediag: 1.1.0.4 +++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++ + C...

New to Extreme...Routing configuration question.

I am new to Extreme coming from a Cisco background and I need some help figuring out the best way to add a new uplink to an ISP. I recently started at this company and my first task is to add a new link to one of our ISPs. They are providing us a 3...

Rate-limit

Hi everybody. I have two Summit x670 (15.4.1.3) switches and I'd like to limit inbound broadcast, multicast and unknown unicast packets on specific ports. So, I've configured rate-limit to 500pps. config port 3 rate-limit flood broadcast 500 config...

Top Kudoed Authors

User

Count

28

28

20

20

17

GTM-P2G8KFN