ExtremeSwitching (EXOS/Switch Engine) - Page 332 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Access-list (rate limiting) and port shares / LAG/LACP

On a Summit-X460, Exos 15/16.x, I have a LAG I also have ingress ACLs (for rate limiting) and egress rate-limits. Do I apply those to all the ports that are part of the LAG, or do I only apply it to the 'config master' port? Thanks!

Problem with SG5201-0848-F6 core switch FUJI TXQ MAIN intr

Today i found in logs with messages on my core switch can someone help me whats the problems i have 2 boned chassis switches. Sep 15 03:24:53 10.10.7.254 Fuji[2.tNimIntr]Fuji TXQ MAIN intr: Fuji=1, Adr=0, Reg=0x00000021 (Adr 31 = 0x1509634F, Adr 32 =...

Can I add acl (block mac address or allow mac address) on snmp

I want to block mac address or I want to allow blocked mac address on SNMP agent Can I do this via snmp ?

Some ports don't link up

Hi, all! X440G2-48t-10G4 Upgraded to recommended EXOS 21.1.5.2 patch 1-2 Diagnostic is passing normal. In logs no any problems. But ports 8, 12, 38, 39, 45, 46 isn't go up when connect some device. Other ports normally working. Tried to del from d...

MPLS route is still active in routing table even its corresponding OSPF route is not listed

Hi There, I found MPLS route is still active in routing table even its corresponding OSPF route is not listed in routing table. Ori Destination Gateway Mtr Flags VLAN Duration mp 192.17.80.55/32 172.17.79.1 ...

Top Kudoed Authors

User

Count

28

26

20

20

17

GTM-P2G8KFN