ExtremeSwitching (EXOS/Switch Engine) - Page 6 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Resolved! Connecting 2x Extreme switches on different floors.

Hello Community,I have 2 x 5520 switches based over 2 floors. I believe I cannot stack these due to the distances involved. However, I do have a fibre connection between the 2 floors.What is the correct way of connecting these 2x 5520 switches? Id...

Resolved! Problems with PTPv2 on X440G2

I have a problem with the synchronization of Unify base stations over the PTPv2 protocol on the X440-G2 switches. These stations synchronize with each other, one of them is the reference clock. Do these switches support PTP. I found information that ...

Doubts to configure redistribution

Hi all,It's my first time configuring an extreme network switch. I have a 5420f stack running EXOS. I have configured one VLAN with OSPF and the other Vlan with RIP.Now I would like to redistribute RIP into OSPF and OSPF into RIP. All route type. I w...

Resolved! Layer 3 VLAN design for Aggregation to Core Routing

I am new to Extreme, coming from the Cisco world. I have read that there are no "routed" ports on EXOS/Switch Engine but you create a vlan and assign only that vlan to the ports. I have a lab where I have 2 cores, 2 aggs, and 2 access layer switches....

Resolved! PA System Fixed By Turning OFF IGMP Snooping... Why?

Hello. This one had us stumped and in many cases, still does.For context, I am running 5420M-48W-4YE edge switches, and over the winter break (we are a k-12 school) I pushed a firmware update to my switches, bringing them to 3.6.1.5.Over the past few...

Top Kudoed Authors

User

Count

28

23

17

16

16

GTM-P2G8KFN