ExtremeSwitching (EXOS/Switch Engine) - Page 673 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

resets without loss of power

Summit 670 resets when we have a power outage. The device has two power supplies. Both of which are plugged in to separate UPS's. The logging on the UPS shows that that voltage levels never dropped below 118vac and the load on the UPS was constant. ...

Should or can I configure ELRP on ports that have been setup with LACP?

Should I configure ELRP on ports that have been setup with LACP? I have 2 Summit switches with MLAG, and ports 48 on each switch are set for LACP. A server will have a connection to each port. Or will ELRP disable the port by default.

Upgrade Image

Hi, I have a switch X440-48P running on image ver 15.2.1.5 on both Primary and Secondary and the use image was on Primary. I have perform a firmware upgrade on the Secondary to image ver 15.3.1.4 and when the installation comple...

TACACS+ configuration

Hello, colleagues! Earlier was post about TACACS conf - https://community.extremenetworks.com/extreme/topics/tacacs_server_setting_admin_setting-f140e But now I have question. When I enable TACACS on switch, I can't login with TACACS account (is pre...

How to display maximum throughput of the routing engine on a XOS switch

We would like to know how much data is going through the routing engine of a BD8800, in other words how much traffic is routed by the switch (the actual maximum we would like to learn)

Top Kudoed Authors

User

Count

33

29

22

20

17

GTM-P2G8KFN