ExtremeSwitching (Other) - Page 57 - Extreme Networks

ExtremeSwitching (Other)

Questions and discussions about switching in general

Forum Posts

Sorted by:

Start a conversation

Show Last interface status change 200-series

Hello Is there a command on the 200-series Extreme switches to see the last interface change?For example, Last up: 3 daysLast down: 2 days This output is available on the EXOS series (show port 1 information detail) and I need it also on the 200-...

what are the steps to configure stack on the extreme 220 switches

Hi Team, How to configure stacking on the extreme 220 switches? Extreme 220) (Config)#stack (Extreme 220) (Config-stack)#stack-port 1/0/26 stack We are using the ring topology, so any other configuration need or not?

Routing the Management address over an LACP lag

I am banging my head against the table trying to get my management IP routing across a LACP lag from my 220 a Dell F10 switch. In my early troubelshooting, I was just trying to get pinging working, which it still is not over a LAG. I was able to ge...

How to configure voice and data vlan on the same 200 series switch

Hi Team, we have 2 VLANs for voice and data, we need to access both VLAN on the same 200 series switch port. what are the procedures to configure the switch port?

How to remove stack unit from extreme 220 switch

Hi Team, stacked 2 extreme 220 switches, after removing one switch from the stack and erase all start-up configuration but still showing unit 2 in the first switch. how to remove unit 2 from the first switch?

Top Kudoed Authors

User

Count

28

4

4

3

3

GTM-P2G8KFN