ExtremeSwitching (Other) - Page 77 - Extreme Networks

ExtremeSwitching (Other)

Questions and discussions about switching in general

Forum Posts

Sorted by:

Start a conversation

What is the network requirements for SCADA systems communications?

We are deploying a multi-ring network using 100+ X440 and one BD 8806. from Core to any location we are having less than 15ms delay, but still the guys from SCADA system complaining that it's too much for their system, So I need a reference for the ...

Resolved! How can I troubleshoot the poe switch. all ports suddenly shut down.

How can I troubleshoot the poe switch. all ports suddenly shut down. the main problem is it was stacked to other switches. I don't know how to configure it in master slot 1. or are I going to pull out the defective switch then how to troubleshoot th...

(pending-AAA) login:

I pulled out a switch from stacking it is a STANBY mode. But now this is the scenario. (pending-AAA) login: Warning: the stack has no Master node and all active nodes are operating with master-capability turned off. If you wish to reconfigure...

Can't Access Switches With Loss To LDAP via NAC

Hi, Currently have all switches in the network doing management login via Radius Via NAC and then onto LDAP to AD. The problem has arisen, although two AD (LDAP Connections) have been configured, where Full loss to both the LDAP services has occurr...

debug packet capture not working

Hi,Just trying to run a debug packet capture on the following:Stack of 4 x X450G2-48P-10G4, running version 22.2.1.5-patch1-4As per the following GTAC articles:https://extremeportal.force.com/ExtrArticleDetail?an=000079573 (This article is slightly w...

Top Kudoed Authors

User

Count

28

4

4

3

3

GTM-P2G8KFN