ExtremeWireless (WiNG)
Questions and discussions about WiNG devices
cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

AP7632 connection problem

Hello!Dear experts, i need your kindly advice, please.. I have an AP7632i access point, which operates in a bridge mode. It looks like AP works fine, but some kinds of clients can't receive an IP address from the gateway through this AP. As a result,...

AmirA by New Contributor
  • 849 Views
  • 0 replies
  • 0 kudos

MIB for PRTG

I'm looking for a MIB that I can use on our controller to show if an AP is online or offline in prtg. I've not had much luck because I'm honestly not well versed on these things. Can anyone help me out?

Resolved! Disconnect clients based on their signal Strength

Hello community,I'm trying to configure AP410i to disconnect clients that falls below -75db, but in wireless configuration I cannot find any settings related to minimum signal strength, signal threshold or similar.Can anybody point me in the correct ...

adf10 by New Contributor III
  • 2272 Views
  • 2 replies
  • 0 kudos

AP410 Radio 3 sensor

Hello Community,I have a group of AP410i deployed on an office building, with Radio1 configured on 2.4Gz , Radio2 on 5Ghz and Radio3 enabled and configured as sensor. Some APs reports Radio3 in State OFF like this:But some of the APs reports Radio3 a...

adf10_0-1702675036595.png adf10_1-1702675286341.png
adf10 by New Contributor III
  • 1597 Views
  • 2 replies
  • 0 kudos
GTM-P2G8KFN