ExtremeWireless (WiNG)
Questions and discussions about WiNG devices
cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Resolved! AP5010 WING Mode MGMT CLI Access

Hi All. Need some guidance here:After AP5010 is switched from XIQ to WING mode - can its MGMT CLI interface be accessed via zero config IP address by the eth0/eth1 port, or can it only be accessed via the microusb console port? Asking this because th...

oxoyoz by New Contributor III
  • 2496 Views
  • 3 replies
  • 2 kudos

NX5500 Controller at 29% CPU - dropping snmp

We have a cluster pair (Active - Standby) of NX5500 controllers running on 5.9.1.5 firmwareThey're supporting a mixture of AP6532 and AP7632 APs, totalling 104. The AP6532 APs stop us from upgrading the firmware, until they are replaced.We monitor va...

colink by New Contributor
  • 1343 Views
  • 2 replies
  • 0 kudos

radius configuration on AP7522

Hi.I'm doing an intership and I'm trying to configure un radius server on a AP7522. My server is all set on a Windows server 2019. I'm trying to configure the wifi AP (AP7522) and frankly I'm lost. I've tryed every ressource I could think of (I've ev...

Akalzed by New Contributor
  • 3089 Views
  • 7 replies
  • 3 kudos

Clients don't get IP address

Hello,Clients can't get IP addresses from DHCP server on one of the WLANs. We have several WLANs and all work except one.APs are 7532 and 2 NX5500 controllers. DHCP server is on Huawei Firewall. All WLANs on different VLANs. APs connect to controller...

st3rling by New Contributor
  • 976 Views
  • 1 replies
  • 0 kudos

Wing AP connection is bad

My Wing AP connection is bad.My Devices : AP310i, NX5500(7.7.1.3)I had these symptoms:1. SSID Connection is too slow or disconnect suddenly.2. Ping is disconnected suddenly a few times. (or have a high latency)3. When I use the third-party vendors AP...

GTM-P2G8KFN