MIB for PRTG
I'm looking for a MIB that I can use on our controller to show if an AP is online or offline in prtg. I've not had much luck because I'm honestly not well versed on these things. Can anyone help me out?
Forum Posts
Resolved! Disconnect clients based on their signal Strength
Hello community,I'm trying to configure AP410i to disconnect clients that falls below -75db, but in wireless configuration I cannot find any settings related to minimum signal strength, signal threshold or similar.Can anybody point me in the correct ...
AP3935I declaration of conformity EU
Hello,Could you please help me locate DoC for this model?Valentas
AP410 Radio 3 sensor
Hello Community,I have a group of AP410i deployed on an office building, with Radio1 configured on 2.4Gz , Radio2 on 5Ghz and Radio3 enabled and configured as sensor. Some APs reports Radio3 in State OFF like this:But some of the APs reports Radio3 a...
Problem with connetion via WiFi
Hello. I have ~10 AccessPoints AP410i (wing 7.7.1.8-009R) which work in same domain and select virtual controller via option "Enable auto election of VC".Created some vlan, linked to Wlan - Radio2 (5hz).I see and can connect to my SSID, get ip addres...
