ExtremeSwitching (ERS)
Questions and discussions about ERS
cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Stacking and Lag

Dear Friends , I am very new to extreme switches and i am stuck in stacking and making lag ports can some one please help me on this topic.model ERS3626GTS-PWR+I tried to stack switches but its not stacking. Kept primary switch in base on mode.  

Israr by New Contributor
  • 1088 Views
  • 1 replies
  • 0 kudos

ERS 3524 Configure port with ip (routed interface)

We are installing a uCPE at one of our locations, and we are tasked with configuring a port with a specific IP for the uCPU to connect. I assumed that the ERS is a layer 3 switch. You can do this on cisco switched using the no switchport command. Is ...

known1 by New Contributor
  • 2008 Views
  • 4 replies
  • 0 kudos

Resolved! restore config from backup

Hi,I'm trying to transfer a backup from a 3549GTS-PWR+ to another 3549GTS-PWR+, but I get an error “Cannot use configuration data from a different type of Baystack module. Operation aborted.”I use FW:5.3.0.10 and SW:5.3.12.009 on both switches.The on...

Isar1 by New Contributor II
  • 5971 Views
  • 8 replies
  • 0 kudos

Resolved! ERS4900/5900 config audit logging

Hi folks!! I need enabled audit logging in ERS4900/5900 series, but I not sure if the only option available is enabling enhanced secure mode on switches which is no option due to all changes that introduces in users and password management. Any idea?...

EF by Contributor III
  • 2124 Views
  • 3 replies
  • 0 kudos

Resolved! How to load and execute a script to an ERS switch?

Hi all, I am trying to figure out a way to load a script and store it on an ERS switch (in my case 4800 running 5.12 code) and then execute it.  I have figured out the script blocks but those appear to just be pointers to off board scripts that get u...

JackS by New Contributor
  • 4979 Views
  • 5 replies
  • 0 kudos
GTM-P2G8KFN