ExtremeSwitching (EXOS/Switch Engine) - Page 59 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Resolved! What VIM module works in a 5520 for both 1g and 10g?

We have multiple 5520 switches that have a VIM4-X module in. The issue with this module is that it only passes IP traffic with 10GB SFP+ modules in them. 1GB SFP modules will link up but no IP traffic will go across the link.I'm in a situation wher...

X450-G2 as core switch

We have a Sonicwall NSA3600 running DHCP, and this connected to the 'core' Aerohive SR2324P, which plugs into a few dozen mixed devices, (AP's, computers, etc) and 4 other SR2324P throughout the site via 10g fibre. These SR2324s in each building con...

port down due to vlacp

one uplink not comming UP due to vlacp operationally down but admin up.

Trouble to get 100BASE-X SFP to work on X465-24s

Hello community,I'am using 2 x456-24s Extreme Fiber switches. I've read that those switches should support 100BASE-X, but in my case they wont.I think maybe i have wrong SFP modules - i have tried EDGE sfps (i've had positive experiences between edge...

Stack shows config changes pending after reboot....

Stack of two 5420F-48P-4XE running 31.7.1.4 - brand new setup, new config. If I save the config (successful save, no issues), then reboot the stack, upon login the CLI prompt shows* Slot-1 4th-stack-new.2 #as if there's a config change pending (the ...

Top Kudoed Authors

User

Count

28

26

20

20

17

GTM-P2G8KFN