ExtremeSwitching (EXOS/Switch Engine) - Page 687 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Max-Burst-Size and Egress Rate Limiting

Hello Everybody, Can anyone explain the 'max-burst-size' variable as it relates to egress rate limiting in the command below? configure ports rate-limit egress [no-limit | [Kbps| Mbps | Gbps] {max-burst-size [Kb | Mb]}] More specifically, if I'...

MPLS PW and IP forwarding

Is there any way to terminate a pseudo-wire on a VLAN with IP forwarding enabled? Consider a scenario where a provider network is L2 back to a routing core - a classic scenario might be an EAPS ring around a number of edge switches, with a pair of c...

How to add protocol ospf to Virtual Router of type VPN-VRF?

create vr "CAMPUS" type vpn-vrf vr "VR-Default" configure vr "CAMPUS" add protocol ospf Error: Protocol ospf cannot be configured on Virtual Router of type VPN VRF I need it to be vpn-vrf for our MP-BGP network and I need ospf there, no in default o...

How to copy one Switch configuration to another Switch with encrypted passwords

Hi, i need to copy the config from a LAN attached Switch to a local switch to replace it later? If i run the show conf to get the running config of the LAN attached switch in plaintext and paste it to the local(not LAN Attched device) it will not e...

autonegotiation problem on X440-48t-10G

autonegotiation problem on X440-48t-10G hi, my problem is the tuning speed and mode on ports for old pc , this client works fine on old switch A2H124-48, when I try to connected same client on new sw (X440-48t-10G), the connection not work!!! the le...

Top Kudoed Authors

User

Count

33

29

22

20

17

GTM-P2G8KFN