Hi!!! I have a problem with ciscocdp on matrix E1. I have a C5 and all is working fine. The same configuration has been configured on E1 series but the cisco 3905 does not get the voice vlan configure on the vvid parameter. I know that the device is...
We're observing a higher-than-desired number of "bad" ethernet port > negotiations. On Two ports of this Switch , I ve tried all posible combinations of ( duplex , negocitation speed etc) in both sides, but these ports continues up/down. These po...
Hi! Is there anyone who can explain a bit about the differences between layer 2 and layer 3 load sharing? Why would I choose layer 2 before layer 3 for example? If there's only multicast on the ports, would it be better to use layer 3? Any inform...
B5K125-24P2 is not working, all lamps is on orange color , when i connect switch with console i got this message Enterasys B5-Series Boot Code ... SDRAM Circuit Test of 512 MB 100%
Say the VLAN-Tunnel-Attr as previously returned by Radius is X. We change the Radius config to return Y. After reauthentication (via "set macauth macreauthenticate MACADDRESS") we correctly see the new VLAN-Tunnel-Attr Y using "show vlanauth session...
