ExtremeSwitching (Other) - Page 31 - Extreme Networks

ExtremeSwitching (Other)

Questions and discussions about switching in general

Forum Posts

Sorted by:

Start a conversation

How to replace a failed switch in a stack?

I have two x460-48t switches configured in a stack. I want to create a procedure for replacing one of them if it fails. I searched and found a similar question from a year ago. But the document that was offered as a solution is no longer available to...

Resolved! Additional LAG ports in a stack

Hello.I am new to the community and this is my first post.I am considering placing an older X450e-24p in an area where I need 12 additional switch ports (4 ports need PoE). The edge stack consist of four X440G2-48p switches and has LAG ports going to...

Resolved! configuring eth ports

HelloI have an AP330 and I have successfully configured it as a WIFI access point. I would also like to configure eth0 and eth1 as follows:I would like to connect eth0 to my router (which is also a DHCP server)I would like to connect eth1 to my deskt...

Resolved! B5 and S-Series switch policy profile with multiple rules

I’m assuming this is possible but I’m not sure how to do it.For example based on the GTAC guide “How to Block Bonjour traffic with Policy via Command Line Interface” I know how to drop this IPv4 traffic.I would like to add to this existing rule anoth...

Resolved! Tranciever Information not clear with "debug hal show optic-info port 1"

Hi community, Customer was asking to get an overview about what optics he have in use for a specific campus.I checked that with command:“show port config no-refresh” and got:GERMUESW038.1 # show port 1 config no-refreshPort ConfigurationPort Virtual ...

Top Kudoed Authors

User

Count

28

4

4

3

3

GTM-P2G8KFN