ExtremeWireless (Identifi) - Page 108 - Extreme Networks

ExtremeWireless (Identifi)

Questions and discussions about Identifi devices

Forum Posts

Sorted by:

Start a conversation

cset AP, controller looses antenna selection

Hi, could someone try to see whether that is a general issue.... AP3825e running 10.31 (ROW) If you cset the AP and the AP connects again to the controller the antenna selection is gone and I need to set the right antennas (and also set the radios...

What algorithm is required in an Extreme Switch to connect an AP3825i with LACP enabled ?

Good day. What algorithm should be used in an Extreme Switch to configure Link aggregation and be able to connect an AP3825i with the LACP option enabled? This is the command that has been used: Enable sharing 1 grouping 22,23 address-based algorit...

ExtremeWireless - V10.21 Reports gone new reports

After upgrading V2110 with firmware 10.21.01.0065 I noticed its was not possible to see the clients per VNS or AP. It too bad because I used that report a lot. There is also a new one: 'Channell Inspector'. Verry userfull, But isn't Overlap/Interf...

Add VLAN to Two Ports on Wireless Controller

I have a C4110 wireless controller running 09.21.09.0004. A guest network is B@EWC and assigned as untagged 4000 to port 2. Port 2 connects to a small firewall which connects to a modem. Port 1 serves the staff network. In order to provide wire...

Clients by AP report gone in 10.31

In Version 10.21 the clients by topology and clients by AP reports were removed and replaced with a searchable client report. This report has many problems the biggest being that it does not auto refresh. There has been much discussion on the Hub w...

Top Kudoed Authors

User

Count

20

11

10

8

5

GTM-P2G8KFN