ExtremeWireless (Identifi) - Page 123 - Extreme Networks

ExtremeWireless (Identifi)

Questions and discussions about Identifi devices

Forum Posts

Sorted by:

Start a conversation

EWC: how to configure source interface for RADIUS communication

Hello ! I have an EWC with 2 physical interfaces on esa0 because the customer is in transition to another owner and need to change the VLAN and IP structure globally. For that I need to configure the source IP for radius communication to the new phy...

EWC: later then V9.21.12 - "Guest Portal" Mode seem to be gone

During upgrade some customer EWCs to latest V9.21.15 and later it see that "Guest Portal" Mode is sometimes no more available. On / Till V9.21.12 is see on every (regardless if existing or new) WLAN Service - "Guest Portal" as Authentication Mode a...

C5210 Wireless Controller SNMP v3 User Access

Hi Community I have a quick question regarding SNMP v3 Users on a wireless controller. On the switches I can create SNMPv3 group with read or Write access and add users to the group, on the wireless controller I do not see where I can set restricti...

3912 in mesh bridge configuration

Is it supported to use the 3912 as a mesh AP to make a wireless bridge? Can you then assign VLANs (WLAN services) to the wired ports as usual?

Switchport displayed in NAC v7.0.6.27

NAC v7.0.6.27 I have noticed and am curious why do some devices in my extreme nac report the ap they are connected to, while other devices show the port the ap is connected to? How do I make sure I am always displaying the AP name?

Top Kudoed Authors

User

Count

19

11

10

8

5

GTM-P2G8KFN