I have added 3 AP121s by serial number, but only one shows up under monitor mode. I am unable to onboard them again as they show up as added to my account, but I cannot access them.
I am having trouble with 3 APs that all have a similar serial number. when I plug them in the the go through the boot up process fine but after they have been booted up for a few seconds the status light goes turns off. After 30 sec is blinks white t...
AP250 not booting, Freezed at see below.
Do have any idea?
set attenuator GPIO 7b0f00->7b4f40
gmac_var_init: NAPI2_POLL mode
eth1: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 10.10.80.505_e5.1.2.3 (r659762)
Thanks,
Ivan
We've pushed configs, changing interfaces from phone ports to access and 802.1q trunk ports, yet certain statements remain. Here is an example after going from phone to access:voice vlan Xvoice vlan dscp 46classofservice trust untrusteddescription 'V...
