Aerohive Migrated Content - Page 292 - Extreme Networks

Aerohive Migrated Content

Questions and discussions related to old aerohive products migrated over

Forum Posts

Sorted by:

Start a conversation

Resolved! want to see user ID and other Information from Aerohive in PaloAlto Networks Firewall with PanOS 8.1

want to see user ID and other Information from Aerohive in PaloAlto Networks Firewall with PanOS 8.1

AP121 Wont update to latest version.

I've tried to run the update from hivemanager connect multiple times, but this AP won't update. Any suggestions would be welcome.

Added AP121s don't show up under monitor mode.

I have added 3 AP121s by serial number, but only one shows up under monitor mode. I am unable to onboard them again as they show up as added to my account, but I cannot access them.

Problem with APs not responding

I am having trouble with 3 APs that all have a similar serial number. when I plug them in the the go through the boot up process fine but after they have been booted up for a few seconds the status light goes turns off. After 30 sec is blinks white t...

AP250 not booting, Freezed at see below. Do have any idea? set attenuator GPIO 7b0f00->7b4f40 gmac_var_init: NAPI2_POLL mode eth1: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 10.10.80.505_e5.1.2.3 (r659762) Thanks, Ivan

AP250 not booting, Freezed at see below. Do have any idea? set attenuator GPIO 7b0f00->7b4f40 gmac_var_init: NAPI2_POLL mode eth1: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 10.10.80.505_e5.1.2.3 (r659762) Thanks, Ivan

Top Kudoed Authors

User

Count

4

3

3

3

2

GTM-P2G8KFN