Extreme Networks

oxoyoz · 05-18-2022

Does anyone know the CLI that shows AP's actively connected client devices' (through wifi radios and also ethernet) information, including hostname, mac address, IP address ...etc ?I know the WebUI only shows connected Wireless Clients, but not those...

oxoyoz · 05-12-2022

Hi, I am looking for help troubleshooting below issue: Thanks for your kind help! My setup: Update:Kudos to Angelo Cargnel who helped me figure it out in another thread. Here are the steps I followed to make this setup (aka Router on a stick) succ...

oxoyoz · 05-08-2022

I have 2 VLANs on the AP: VLAN1 and VLAN2I want to assign device A,B,C to VLAN1 and device X,Y,Z to VLAN2 based on the devices' MAC address. For my use case, I cannot simply separate them by connecting them to different WLANs / SSIDs.Thanks for your ...

oxoyoz · 03-22-2022

My AP510E currently has 8 ML-2452-APA2-01 antennas installed. I am using both radio1 and radio2 at 5Ghz band and my antenna setup is 4X4. I plan to replace my antennas with ML-2452-HPAG5A8-01, with the goal to extend signal reception area a bit (I am...

oxoyoz · 03-17-2022

Hi,I am using AP510 as router + AP setting currently. The AP currently runs with 7.6.X firmware.A device connected to AP510 needs to have a 19XXX port (TCP and UDP) forwarded, so that its locally-stored content can be access from external IPs. Does A...

oxoyoz · 06-03-2022

I asked the same question last year and here is the reply:https://extremeportal.force.com/ExtrArticleDetail?an=000098901&q=AP510E%20power Set your 2.4G WiFi channel to 6, and your 5G channel to upper ones on or above 149 -- you should get the highes...

oxoyoz · 05-20-2022

Thanks. Christopher. show ip dhcp binding worked

oxoyoz · 05-19-2022

Thanks. Tobias and Angelo. show mac-address-table gave me the connected devices' mac address on all interfaces. However, this command line doesn't give me other details such as IP address, vendor and state for the devices. Any command to output these...

oxoyoz · 05-11-2022

Thanks Angelo. I am in fact using my AP as a router at the moment because AP's built-in RF module lacks juice (output power) and hence doesn't give me the coverage that I need for a small business place. So I disabled radios on AP510, and connected 2...

oxoyoz · 03-22-2022

Hi Chris,Just want to let you know that your method worked. As long as my WAN IP doesn't change (if it does, then I will have to update NAT rules...), I can access my device from external IPs. Thanks again.

Extreme Networks

User Statistics

User Activity

CLI to show AP's connected devices' information

Devices manually assigned to VLAN2 on AP can not connect to internet

How to assign devices by their MAC address to VLANs on WiNG APs

How many ML-2452-HPAG5A8-01 antennas for AP510E is the ideal setup

WiNG AP510 Port Forwarding

Re: AP510e Maximum Transmission Power at 18dbm

RE: CLI to show AP's connected devices' information

RE: CLI to show AP's connected devices' information

Re: How to assign devices by their MAC address to VLANs on WiNG APs

Re: WiNG AP510 Port Forwarding