Hello @Fawedde,It may also be a config issue. 1 - Have you reset the APs after you acquired them via console port?2 - Are they pulling an IP address?3 - When you say that you can't access via Web and Console, do you mean Web and SSH or the actual con...
Hello @Macknkss,Please make sure that lldp is enabled on both the switch and APs for proper power negotiations. Here's an article on same for your perusal: https://extreme-networks.my.site.com/ExtrArticleDetail?an=000058855BR,
If the AP is in HiveOS mode then it will not be adopted by a WiNG controller and WiNGman will not work with it. You will need to revert it to WiNG OS and then adopt, upgrade and configure. https://extreme-networks.my.site.com/ExtrArticleDetail?an=000...
Hello @ISC-Admin,You said that the radios channel width should be 40Mhz but per the info you provided it looks like it's still 20Mhz. I would recommend the following:From within XIQ revert to Template defaults: https://extreme-networks.my.site.com/Ex...
