Extreme Networks

adf10 · 12-22-2023

I have an AP410C-1-FCC, Console port is a micro USB port. When trying to connect to Windows it reports Unknown USB Device (Device Descriptor Request Failed). I did try with different USB ports, and diferent computer always with the same result. Her...

adf10 · 12-15-2023

Hello Community,I have a group of AP410i deployed on an office building, with Radio1 configured on 2.4Gz , Radio2 on 5Ghz and Radio3 enabled and configured as sensor. Some APs reports Radio3 in State OFF like this:But some of the APs reports Radio3 a...

adf10 · 12-15-2023

Hello community,I'm trying to configure AP410i to disconnect clients that falls below -75db, but in wireless configuration I cannot find any settings related to minimum signal strength, signal threshold or similar.Can anybody point me in the correct ...

adf10 · 04-21-2023

I have an AP7532 which does not boot, connecting with the console it reports Error message: Wrong Image Format for bootm command", "ERROR: can't get kernel image!" as you can see here:ErrorI've waited or max failed attempts but it does not happen. ...

adf10 · 10-12-2022

HelloWe have a warehouse with 133 APs (mix of AP6521, AP7522 and AP7532) connected to RFS4000 controller running WiNG OS 5.9.1.10, we have 2 SSIDs active on different VLANs tunneled to the RFS4000 and sent to the core switch via physical ports.We had...

adf10 · 12-24-2023

Thank you very much for your help Robert, it's greatly appreciated.Best Regards,- Alex

adf10 · 12-18-2023

Hello Jan,Thanks to your help I was able to find the command on the CLI manual to fiddle with this.I'll do my test to find my optimal values.Thank you,- Alex

adf10 · 12-18-2023

Hello Robert,Thank you for your help. Here is my smart-rf-policy configuration:smart-rf-policy defaultassignable-power 5GHz max 20assignable-power 5GHz min 10assignable-power 2.4GHz max 20assignable-power 2.4GHz min 10channel-list 5GHz 36,40,44,52,56...

adf10 · 04-25-2023

Thank you for your suggestion, I've been trying to do as you mention, however Image is downloaded but not booted. I'm using bootp which acording to help can boot a downloaded image from tftp , I also used tftpboot with the same result. Do you know...

adf10 · 10-13-2022

Hello Karol,Thank you for your answer. We are thinking on moving to local bridging and mint link level 2 but I think it will have to wait after december due to high season. On the other hand, appreciate the advice regarding the max number of APs per...

Extreme Networks

User Statistics

User Activity

AP410C-1 probem connecting to console port

AP410 Radio 3 sensor

Disconnect clients based on their signal Strength

Wrong Image Format for bootm command, ERROR: can't get kernel image!

General disconnection from WiFi

Re: AP410C-1 probem connecting to console port

Re: Disconnect clients based on their signal Strength

Re: AP410 Radio 3 sensor

Re: Wrong Image Format for bootm command, ERROR: can't get kernel image!

Re: General disconnection from WiFi