This website uses cookies. By clicking Accept, you consent to the use of cookies. Click Here to learn more about how we use cookies.
Accept
Reject
Help
ExtremeSwitching (ERS)
Questions and discussions about ERS
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Start a conversation

ERS 3500 Series Secure Image with modern web browsers

The newest secure firmware I can find for the ERS 3500 series is 5.3.12 which was released relatively recently.  It still has the known issue of being unable to access through any modern web browsers, which is hardly secure at all.  Is there a newer ...

b4b by • New Contributor
  • 3199 Views
  • 6 replies
  • 0 kudos

How to import certificates to ERS switches

Hi,I am trying to install a certificate to an Ethernet Routing Switch 5952GTS-PWR+   HW:08 FW:7.5.0.4 SW:v7.7.0.003using the instructions in extreme article 000082379I have used openssl to create the certificates using standard RSA 2048 bit.I can imp...

bar by • Contributor
  • 1107 Views
  • 2 replies
  • 0 kudos

VSP and ERS Network challenge

Hello,so i have a VSP from which i have setup a few VLANs onto stacked ERSs on a number of floors, i can reach all switches on the network and almost all the VLANs are fine; but i have two main issues:The IPTv VLAN has been acting up lately; the serv...

Klenan by • New Contributor
  • 6032 Views
  • 18 replies
  • 0 kudos

Clone ERS 4950 Switches

Hello, I’m trying to find how to deploy 200 ERS 4950.I got to update SW version & boot, then choosing spanning-tree mode mst & boot, then spbm & bootI’d like to know how to clone Switches : the aim is not to do all theses steps for every swtich thx f...

Hatem by • New Contributor II
  • 2096 Views
  • 4 replies
  • 0 kudos

Resolved! ERS command : stack reboot-on-failure

Hi, Does anyone have any real world experience with the stack reboot-on-failure setting?The manual is pretty vague, all it says is:  Use this procedure to reboot stack units when the system detects failure of stacking. This is enabled by default. So ...

GTM-P2G8KFN